13 boardings (5 years 3 months)

• Period: August 2024 - October 2024
  Unit: AIDAstella 253m
  Use, area: Cruise vessel
  Role held: 1st engineer
  Main Tasks: My responsibilities as a Senior Eng. Officer of Watch: I was in charge with Ressort 3 which is taking care ofpurifiers units complete: fuel/lube oil for main engines - system with all pump: ballast, sea water, heeling, bilge, lubrication oil and sludge system - compressed air system: start/work air, air dryers, control/working air

• Period: February 2024 - May 2024
  Unit: AIDAstella 253m
  Use, area: Cruise vessel
  Role held: 2nd engineer
  Main Tasks: My responsibilities as a Senior Eng. Officer of Watch: I was in charge with Ressort 1 which is taking care of: - main engine (x4) - cooling water system (HT/LT) - waste heat recovery - main engine lubrication oil system and fuel oil system (fuel/lub. oil transfer and filling system) - fin stabilizer complete - thrusters - mechanical part: shaft, shaft seal, bearing, thrust bearing, shaft turning device, lubricating system

• Period: October 2023 - December 2023
  Unit: AIDAstella 253 m
  Use, area: Cruise vessel
  Role held: 2nd engineer
  Main Tasks: My responsibilities as a Senior Eng. Officer of Watch: I was in charge with Ressort 1 which is taking care of: - main engine (x4) - cooling water system (HT/LT) - waste heat recovery - main engine lubrication oil system and fuel oil system (fuel/lub. oil transfer and filling system) - fin stabilizer complete - thrusters - mechanical part: shaft, shaft seal, bearing, thrust bearing, shaft turning device, lubricating system

• Period: May 2023 - August 2023
  Unit: AIDAstella 253 m
  Use, area: Cruise vessel
  Role held: 2nd engineer
  Main Tasks: My responsibilities as a Senior Eng. Officer of Watch: I was in charge with Ressort 1 which is taking care of: - main engine (x4) - cooling water system (HT/LT) - waste heat recovery - main engine lubrication oil system and fuel oil system (fuel/lub. oil transfer and filling system) - fin stabilizer complete - thrusters - mechanical part: shaft, shaft seal, bearing, thrust bearing, shaft turning device, lubricating system

• Period: March 2023 - March 2023
  Unit: AIDAstella 253 m
  Use, area: Cruise vessel
  Role held: 3rd engineer
  Main Tasks: My responsibilities as a Junior Eng. Officer during dry-dock: - I was in charge with all overboard valves to be overhauled or replaced - boiler system: all valve from feed water and condensate line were doubled, as a safety precaution - 5 years Boiler survey

• Period: September 2022 - January 2023
  Unit: AIDAstella 253 m
  Use, area: Cruise vessel
  Role held: 3rd engineer
  Main Tasks: My responsibilities as a Junior Eng. Officer of Watch: I was in charge with Ressort 1 which is taking care of: - main engines (x4): control air system, start air system, oil mist separator - cooling water system (HT/LT) - waste heat recovery - main engine lubrication oil system and fuel oil system (fuel/lub. oil transfer and filling system) - fin stabilizer complete - thrusters - mechanical part: shaft, shaft seal, bearing, thrust bearing, shaft turning device, lubricating system - cleaning responsibility acc. cleaning plan engine dept. - following vessels SMS procedures (eg. Pre-departure, pre-arrival checklist and procedures) - experienced with InfoShip system (PMS on board)

• Period: March 2022 - July 2022
  Unit: AIDAstella 253 m
  Use, area: Cruise vessel
  Role held: 3rd engineer
  Main Tasks: My responsibilities include as a Junior Eng. Officer of Watch: I was in charge with Ressort 4 which is taking care of: - safety system: hi-fog system / CO2 ext. system /engine room ventilation and firedampers - fire pumps and topping-up pump - high-pressure water systems - quick closing valves for fuel/lub. oil system - bunker station and spill: prepare bunker operation - lifeboats and rescue boat - water tight doors - cleaning responsibility acc. cleaning plan engine dept. - following vessels SMS procedures (eg. Pre-departure, pre-arrival checklist and procedures) - experienced with InfoShip system (PMS on board)

• Period: June 2021 - December 2021
  Unit: M/V Bellatrix 234 m
  Use, area: Container vessel
  Role held: 3rd engineer
  Main Tasks: My responsibilities include: - maintenance and repairs of: fuel/lube oil separators, air compressors, boiler (oil fired and exhaust gas/composite), oily water separator, fresh water makers, sewage treatment plant, incinerator, fuel tanks, water / lubricating / fuel pumps on board. - water analysis (cooling systems/boiler/drinking water) - assisting for repairs of: Main Engine and Auxiliary Engines - following vessels SMS procedures (eg. Pre-departure, pre-arrival checklist and procedures) - experienced with PAL System (PMS on board)

• Period: October 2020 - April 2021
  Unit: M/V Green Wave 172 m
  Use, area: Container vessel
  Role held: 3rd engineer
  Main Tasks: My responsibilities include: - maintenance and repairs of: fuel/lube oil separators, air compressors, boiler (oil fired and exhaust gas/composite), oily water separator, fresh water makers, sewage treatment plant, incinerator, fuel tanks, water / lubricating / fuel pumps on board. - water analysis (cooling systems/boiler/drinking water) - assisting for repairs of: Main Engine and Auxiliary Engines - following vessels SMS procedures (eg. Pre-departure, pre-arrival checklist and procedures) - experienced with PAL System (PMS on board)

• Period: November 2019 - June 2020
  Unit: M/V Cap Capricorn 228 m
  Use, area: Container vessel
  Role held: 3rd engineer
  Main Tasks: My responsibilities include: - maintenance and repairs of: fuel/lube oil separators, air compressors, boiler (oil fired and exhaust gas), oily water separator, fresh water makers, sewage treatment plant, incinerator, fuel tanks, water / lubricating / fuel pumps on board. - water analysis (cooling systems/boiler/drinking water) - assisting for repairs of: Main Engine and Auxiliary Engines - following vessels SMS procedures (eg. Pre-departure, pre-arrival checklist and procedures) - experienced with PAL System (PMS on board)

• Period: September 2019 - November 2019
  Unit: M/V Cap Capricorn 228 m
  Use, area: Container vessel
  Role held: Junior engineer
  Main Tasks: My responsibilities include: - working closely with the 3rd engineer on planned/unplanned maintenance and repair jobs - prepare to take over 3rd engineer position and duties

• Period: September 2018 - March 2019
  Unit: M/V Cali 228 m
  Use, area: Container vessel
  Role held: Engine cadet
  Main Tasks: My responsibilities include: - to be proactively engage to benefit from professional knowledges and development. - perform all engineering duties aboard ship under supervision of a licensed engine officer. - assist in all engineering related tasks both operational and maintenance.

• Period: December 2017 - May 2018
  Unit: M/V Kota Ekspres 228 m
  Use, area: Container vessel
  Role held: Engine cadet
  Main Tasks: My responsibilities include: - be effective in relating to others - able to work well under pressure - stops work if unsafe conditions or practices are observed as per vessel’s safety procedures and COSWP - cleaning workplaces

• Attached documents available for reading
• H.E.L.M.

  IMO Title

  Issuing date: 24 March 2023
• Simulator for Mechanical officer

  Other document

  Expiration date: 21 February 2028
• ENG1

  Medical Certificate

  Expiration date: 06 November 2026